Tektronix MDO34 User Manual

Field or control Description
FD Bit Rate Select the FD bit rate of your CAN FD serial bus data.
T
o enter a custom bit rate, select Custom and enter the custom bit rate in the Custom Rate input box.
This field is only available when CAN Standard = CAN FD.
Custom Rate Sets the custom bit rate to use to decode the signal. Tap the field and use the Multipurpose knob to
change the value, or double-tap on the field and use the virtual keypad to enter a custom bit rate.
This field is only available when Bit Rate, SD Bit Rate, or FD Bit Rate = Custom.
Display Format Bus sets the waveform view to show just the decoded bus information.
Bus and Waveform sets the waveform view to show both the decoded bus and the logical views of
each constituent signal.
You can also tap on the + symbol on the bus waveform to toggle between showing the bus only or
showing bus and source waveforms.
Decode Format Sets the decode format used to display the bus information. Formats are Hex, Binary, and Mixed Hex.
Mixed Hex displays some fields as binary, and other fields as hexadecimal.
Other bus types
Serial bus types, such as CAN, LIN, Ethernet, and so on, are available as purchasable options. Once purchased and installed, the new bus
types are shown in the Bus T
ype menu. The serial bus options also add corresponding bus trigger capabilities to the Trigger menu.
Use the following links to access information on specific Bus configuration menus.
Parallel Bus configuration menu on page 127
I2C serial bus configuration menu on page 123
SPI serial bus configuration menu on page 131
RS-232 serial bus menu on page 129
CAN serial bus configuration menu on page 120
LIN serial bus configuration menu on page 124
FlexRay serial bus configuration menu on page 122
Audio serial bus configuration menu on page 118
USB serial bus configuration menu on page 132
MIL-STD-1553 serial bus menu on page 126
ARINC429 serial bus menu on page 117
See also
Menus and dialog boxes
3 Series Mixed Domain Oscilloscope Printable Help 121

Tektronix MDO34 Specifications

General

Analog Channels	4
Sample Rate	2.5 GS/s
Record Length	10 Mpoints
Mixed Domain Analysis	Yes
Waveform Capture Rate	>280, 000 wfms/s
Spectrum Analyzer Frequency Range	9 kHz to 3 GHz
Vertical Resolution	8 bits
Input Coupling	AC, DC, GND
Operating Temperature	0°C to +50°C
Digital Channels	16
Connectivity	USB, LAN, HDMI
Arbitrary Function Generator	50 MHz
Trigger Types	Edge, Pulse Width, Runt, Logic, Setup/Hold, Rise/Fall Time, Video
Input Impedance	1 MΩ
Maximum Input Voltage	300 Vrms
Dimensions	140 mm
Weight	4.5 kg
Bandwidth	100 MHz, 200 MHz, 350 MHz, 500 MHz
Display	10.1-inch capacitive touch HD display
Voltmeter	4-digit