Tektronix MDO34 User Manual

Display and configure cursors
Cursors are on-screen lines that you can move to take measurements on specific parts of a waveform. Cursor readouts show both current
position values and the dif
ference (delta) between cursors.
Procedure
1. Tap the Cursors button, or push the front-panel Cursors button.
The cursors are added to the display.
2. Use Multipurpose Knobs A and B or touch and drag to move the cursors. Cursors show readouts that show position and dif
ference
measurements between the cursors.
3. To further configure cursors, double-tap on either cursor line or the cursor readouts to open the Cursors configuration menu. For
example, tap the Cursor type to select the cursors to display, such as Waveform.
4. T
ap the Help icon on the menu title for more information on the menu settings.
5. To stop showing cursors, push the front panel Cursor button or open the Cursors configuration menu and set Display to Off.
Using Default Setup
Use Default Setup to restore instrument settings to their factory defaults.
Procedure
1. Press the front panel Default Setup button to return the instrument to its factory default settings (horizontal, vertical, scale, position,
and so on).
Analog channel operating basics
3 Series Mixed Domain Oscilloscope Printable Help 78

Tektronix MDO34 Specifications

General

Analog Channels	4
Sample Rate	2.5 GS/s
Record Length	10 Mpoints
Mixed Domain Analysis	Yes
Waveform Capture Rate	>280, 000 wfms/s
Spectrum Analyzer Frequency Range	9 kHz to 3 GHz
Vertical Resolution	8 bits
Input Coupling	AC, DC, GND
Operating Temperature	0°C to +50°C
Digital Channels	16
Connectivity	USB, LAN, HDMI
Arbitrary Function Generator	50 MHz
Trigger Types	Edge, Pulse Width, Runt, Logic, Setup/Hold, Rise/Fall Time, Video
Input Impedance	1 MΩ
Maximum Input Voltage	300 Vrms
Dimensions	140 mm
Weight	4.5 kg
Bandwidth	100 MHz, 200 MHz, 350 MHz, 500 MHz
Display	10.1-inch capacitive touch HD display
Voltmeter	4-digit