Tektronix MDO34 User Manual

3. Double-tap the Enter License Key field to open the virtual keyboard.
4. Use the virtual keyboard to enter the license key
. The key is not case sensitive.
5. Tap OK. The instrument installs the license and returns to the About screen.
6. Power cycle the instrument to enable the installed option(s).
7. Return to the Help > About menu to verify that the Enabled status for the option is Yes.
8. If you installed a bandwidth upgrade, remove the model/bandwidth label from the lower-left corner of the front panel and install the
new model/bandwidth label that your received as part of the upgrade purchase. If you installed a bandwidth upgrade, run signal path
compensation (Utility > Calibration > Run SPC).
Option upgrades
3 Series Mixed Domain Oscilloscope Printable Help 31

Tektronix MDO34 Specifications

General

Analog Channels	4
Sample Rate	2.5 GS/s
Record Length	10 Mpoints
Mixed Domain Analysis	Yes
Waveform Capture Rate	>280, 000 wfms/s
Spectrum Analyzer Frequency Range	9 kHz to 3 GHz
Vertical Resolution	8 bits
Input Coupling	AC, DC, GND
Operating Temperature	0°C to +50°C
Digital Channels	16
Connectivity	USB, LAN, HDMI
Arbitrary Function Generator	50 MHz
Trigger Types	Edge, Pulse Width, Runt, Logic, Setup/Hold, Rise/Fall Time, Video
Input Impedance	1 MΩ
Maximum Input Voltage	300 Vrms
Dimensions	140 mm
Weight	4.5 kg
Bandwidth	100 MHz, 200 MHz, 350 MHz, 500 MHz
Display	10.1-inch capacitive touch HD display
Voltmeter	4-digit