Telos TWOx12 - Getting Started and Installation Checklist

TELOS TWOX12 USER’S MANUAL
INSTALLATION
CHAPTER 2 7
2 INSTALLATION
2.1 Getting Started
In this chapter we will cover the various input/output connections of the TWOx12 and what
you need to know to install the system. We also give you a brief introduction to ISDN in
section 2.3 since some users may not be familiar with it. Later, in section 3, we will cover
the steps necessary to configure the unit for initial operation and test it. Section 7 has a
detailed reference of all menus.
The Telos TWOx12 mounts in a 2RU high space in a standard 19” rack. You do not need
to pay special attention to cooling or ventilation, as the unit will operate in any environment
where humans would be comfortable. The unit will operate on any commonly available AC
mains voltage between 90 and 240 volts 50 – 60 Hz. You will want to mount the unit in a
position convenient for cable access for the ISDN lines and audio connections.
Next, you will need to:
• *Order or confirm availability of appropriate ISDN BRI lines
• Connect the Telco circuits
• Connect audio, via either analog or digital AES/EBU
• Connect 1 or more Desktop Directors (control surfaces)
• Connect to power
• Connect to LAN (local area network), if Call Screen Manager 2.0 is to be used
• *Configure the TWOx12 to match your ISDN lines
• Configure the built in hybrids’ audio characteristics for the requirements of your
installation
• Test to confirm proper operation
* This step can be skipped if analog (POTS) telephone lines are used.
w
IMPORTANT!
This manual goes into detail about ordering & using ISDN, and programming information
into the unit about your ISDN lines. If you purchased the POTS (analog) version of the
TWOx12 you can disregard that information.