Telos TWOx12 - Menu Navigation; Changing from Talent to Producer Mode

TELOS TWOX12 USER’S MANUAL
DESKTOP DIRECTOR GUIDE FOR CALL SCREENERS
CHAPTER 5
PLEASE COPY THIS SECTION AND GIVE TO YOUR CALL SCREENERS
85
Producer
The default Desktop Director LCD Screen
w
IMPORTANT!
Since certain functions work differently in “
Talent”
versus “
Producer”
mode it is
important that you understand that there are two modes, and how to switch between
them. This is covered below.
5.4.1 Menu Navigation
The LCD screen and menu navigation buttons are used to set volume settings, LCD
screen backlight and contrast, and to select the “mode” for a particular Desktop
Director™. The function of the three “soft keys” immediately below the LCD screen
will vary depending on context and will always be displayed on the screen. In most
cases the center soft key offers context sensitive HELP and the left soft key offers a
BACK function. The BACK function takes you back to the default screen without
saving unconfirmed changes.
The 6 & 5 buttons scroll through the options in a menu while the Select button
chooses a menu selection or confirms an entry. In the volume menus 6decreases the
volume while 5 increases it.
5.4.2 Changing from Talent to Producer mode
At any given time each Desktop Director™ is in either Producer or Talent mode.
This can be changed at any time on each Director in the system. Producer mode can
be thought of as “Screener phone” mode while Talent mode can be thought of as “on-
air control” mode. As discussed earlier, the function of certain buttons is different in
these two modes. To change from Talent mode to Producer mode:
• Press the soft key button below the word MODE. You should now see a
screen that looks similar to the following.
Configuration Menu
%
Director Mode
Contrast
Backlight
MODE HELP VOLUME
BACK HELP