Telos TWOx12 - Page 216

TELOS TWOX12 USER’S MANUAL
ISDN BRI ORDERING GUIDE FOR ETS 300 (EURO ISDN)
APPENDIX 6 204
ISDN BRI LINE ORDERING INFORMATION
ETS 300 (not for use in USA & Canada)
Telos TWOx12
To: Telecom
Attention:
From: Location for line:
Company: Company:
Address: Address:
City/State/ZIP: City/State/ZIP:
Phone: Phone:
Contact: Contact:
Long distance carrier: Number of ISDN-2 (BRI) circuits required:
Date needed: Termination date:
We request the above number of ISDN Basic Rate Interface (ISDN-2, BRI, S∅) circuits for use with the
Telos TWOx12 digital telephone system. This device interfaces audio equipment to digital telephone
services. It requires Circuit Switched Voice (CSV). We may also use this line for other equipment which
makes calls using Circuit Switched Data (CSD) service.
TWO has an integral BRI terminal adapter which supports the ETS 300 (Net3) protocol.
We require a standard “S” (4-wire) interface on a standard, eight-pin/4-conductor RJ45-style modular jack,
of which only the center four conductors will be used.
Hunt Groups (please give us the option specified below):
❏ Please place all MSNs for all BRI’s in a single hunt group (ISG or rollover group) Or
❏ Please create a hunt group with all MSNs except (Specify)________________________
❏ No Hunt groups
Line Deactivation (please provide the option specified below):
❏ Our application is critical and we need to ensure that lines are working at all times. Please set the switch
parameter “Deactivation Allow” to “NO”.
❏ We would prefer to know if lines are working at all times. Therefore we request that you set the parameter
“Deactivation Allow” to “NO” if this is possible.
❏ Line deactivation is acceptable; Please provide your default setting for this parameter.
You may call the manufacturer of the TWOx12, Telos Systems, at +1 (216) 241-7225 for any additional
required information about ISDN compatibility. Ask for Telos TWOx12 Customer Support.