Telos TWOx12 - Page 223

TELOS TWOX12 USER’S MANUAL
ISDN BRI ORDERING GUIDE FOR USA & CANADA
APPENDIX 7 211
PROTOCOL: National ISDN-1
From AT&T 5ESS, Northern Telecom DMS100, and Siemens EWSD.
If you use IOC Capability Packages, please use Capability Package ‘S’ unless otherwise specified.
CO Values
Line Type: National ISDN-1
Bearer Service: CSD/CSV on both channels (CSV is required; CSD may be omitted if requested by
user)
TEI: One dynamic per number
Turn off features such as; packet mode data, multiple call appearances, Electronic Key Telephone
Sets (EKTS), shared directory numbers, accept special type of number, intercom groups, network
resource selector (modem pools), message waiting, hunting, interLata competition, etc.
NOTE for EWSD running NI-2: Switch must be programmed CLID=DN
Note for AT&T/Lucent 5ESS on loop extended lines: REX test must be disabled for this line
using one of the following: ASDFI266 (Prohibit REX on BRI lines per office) or ASDFI267
(Prohibit REX on BRI lines per line)
Give us:
1) Two SPID numbers, depending upon number of active B channels
2) Two Directory Numbers
PROTOCOL: Northern Telecom DMS100 “Functional” (Custom, PVC1)
Northern Telecom DMS100 switches BCS 31 and above.
CO Values
Line Type: Basic Rate, Functional
EKTS: No
Call Appearance Handling: No
Non-Initializing Terminal: No
Circuit Switched Service: Yes
Packet Switched Service: No
TEI: Dynamic
Bearer Service: CSD/CSV on both channels (CSV is required; CSD may be omitted if requested by
user)
Give us:
1) Two SPID numbers, depending upon number of active B channels
2) Two Directory Numbers