Telephone Line Emulator User’s Manual
40-400-00020, Rev. M 112
Error Message: The current configuration of your unit might not be valid, or may require
an upgrade to the TLE_PC software. For the latest version of TLE_PC
software, see Teltone’s web site at www.teltone.com. Do you wish to
reconfigure the unit to a compatible version now?
Explanation: The TLE_PC software has detected a combination of Boot Code,
Microcontroller Code and DSP Code versions which are not listed in it’s
current list of compatible versions. This could be due to a corrupted
code in the TLE, or newer code having been downloaded to it while
connected to a different PC.
Reconfiguring the unit will download the latest compatible versions of
microcontroller and/or DSP code which are on that PC.
Note: Newer versions of TLE_PC software are compatible with all
previous TLE configurations. It is recommended that users always
install the latest version of TLE_PC software on all systems which they
use to configure TLEs.
Error Message: Not active in this configuration.
Explanation: Selecting items in the “Find” dialog which are not compatible with the
configuration type being edited will result in this message.
Miscellaneous Error Messages
Error Message: “SIT + Audio” and “SIT Repeating” cannot both be selected. If you wish
to select “SIT + Audio”, you must first remove all selections for “SIT
Repeating” from the other lines.
Error Message: “SIT + Audio” and “SIT Repeating” cannot both be selected. If you wish
to select “SIT Repeating”, you must first remove all selections for “SIT +
Audio” from the other lines.
Explanation: The above two messages are displayed if the user attempts to program
the “Response to Invalid” for different lines to both “SIT + Audio” and
“SIT Repeating”. These two selections are mutually exclusive.
Audio Related Error Messages
Error Message: Total length of all messages must not exceed 8 seconds. The current
total is “x” seconds.
Explanation: The user has selected voice files which total more than 8 seconds in
length (voice file lengths are rounded up to the nearest half second).
The user must select voice files which total no more than 8 seconds.
Error Message: File “filename” has changed and the total length of all messages now
exceeds 8 seconds. The current total is “x” seconds.
Explanation: A voice file which had previously been selected has been edited and/or
replaced by a file which is longer than the original, and the total of all
selected messages now exceeds 8 seconds. The user must select voice
files which total no more than 8 seconds.
To Next Page
Loading...