B.28 MSP-TS430RGC64USB
Due to the use of diodes in the power chain, the voltage on the MSP430F5xx device is approximately 0.3 V
lower than is set by the debugging tool. Set the voltage in the IDE to 0.3 V higher than desired; for example, to
run the MCU at 3.0 V, set it to 3.3 V.
www.ti.com Hardware
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
Submit Document Feedback
MSP430™ Hardware Tools 117
Copyright © 2020 Texas Instruments Incorporated
To Next Page
Loading...
