Jumper JP2
Open to measure current
Orient Pin 1 of MSP430 device
Jumper JP3
Open to disconnect LED
D1
LED connected to P1.0
Connector J5
External power connector
Jumper JP1 to "ext"
Jumpers JP4 to JP9
Close 1-2 to debug in Spy-Bi-Wire mode
Close 2-3 to debug in 4-wire JTAG mode
Connector JTAG
For JTAG Tool
Connector BOOTST
For Bootloader Tool
Jumper JP1
1-2 (int): Power supply from JTAG interface
2-3 (ext): External power supply
Figure B-23. MSP-TS430PW28A Target Socket Module, PCB (Red)
Note
For bootloader use, the BSL connector and only one of the resistors R2 or R3 need to be populated. If
the board is supplied internally, R3 (0 Ω) must be assembled. If the board is supplied externally, R2 (0
Ω) must be assembled, and R3 must be removed.
Hardware
www.ti.com
64 MSP430™ Hardware Tools SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
Submit Document Feedback
Copyright © 2020 Texas Instruments Incorporated
To Next Page
Loading...
Need help?
General
