108
BRAKES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Figure 18 Pedal Cover
3. Remove four screws (6) securing the brake pedal
assembly to the floorboard. (Figure 19)
4. Disconnect the wires from the brake enable switch
(8).
5. Disconnect the accelerator pedal kick-off linkage (1)
from the cam by removing the bolt (4).
6. Disconnect the equalizer (2).
7. Remove the c-clip (10) from the pivot pin (9) to
release the equalizer and brake cables.
8. Place pedal assembly in position on the floorboard
and secure with four socket head bolts (6) and
tighten to torque value specified below.
9. Reinstall both the brake cables (11 and12) into
equalizer (2) refer page M13.
10. Reconnect the accelerator brake pedal kick-off link-
age (1). For adjusting the Brake Pedal free travel
refer page M9.
11. Reconnect the Wires and brake enable switch (8)
oriented as shown.
12. Install the pedal cover (14), using new rivets (15),
replace the floormat and rocker panels.Replace any
worn or damaged hardware with new as required.
BRAKE FAULT TESTING
For brake fault testing, refer to fault testing section in the
manual only after the thorough visual inspection, Periodic
Brake Performance Test (PBPT), and Aggressive Stop
Test have been performed.
Figure 19 Brake Pedal
Item Torque Specification
6
14.7 - 15.8 ft. lbs. (20 - 21.5 Nm)
To Next Page
Loading...
Need help?
General
