Textron EZGO RXV 2016 User Manual

SPEED CONTROL
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
43
Tighten the bolt (18) to the torque value specified below.
Accelerator Cable Removal at Governor
To remove the accelerator cable (9) from the governor,
loosen the nuts (13) securing the cable (9) to the acceler-
ator cable bracket (14) at the rear axle and unhook the
spring from the upper governor lever (15).
Figure 4 Accelerator Cable at Governor
Accelerator Cable Removal and Installation
at Pedal
To access the accelerator cable at the accelerator pedal,
remove the upper rocker panels, the lower rocker panels
and the floormat. Remove four ratchet rivets (1) securing
the pedal cover (2) to the floorboard and remove the
cover from the pedal area (Figure 5).
To remove the accelerator cable from the accelerator
pedal remove the rubber snap-in holding the cable to the
floorboard (Figure 6). Rotate the cable upward until the
bullet lifts out of the slot in the pedal arm. Remove any
wire ties holding the cable and loosen the nuts securing
the cable to the accelerator cable bracket at the rear axle
and lift cable from bracket. Unhook cable from the accel-
erator compression spring and yoke.
Figure 5 Accelerator Pedal Access
Figure 6 Accelerator Cable Installation
Installation of the accelerator cable is the reverse order of
removal.
Accelerator Pedal Arm Adjustment
Tool List Qty.
Needle Nose Pliers......................................................1
Phillips Screwdriver .....................................................1
Open End Wrench, 9/16".............................................1
Open End Wrench, 1/2"...............................................1
Open End Wrench, 7/16".............................................1
Open End Wrench, 3/8"...............................................1
Allen Wrench, 1/8" .......................................................1
Lift front of vehicle using procedures and safety informa-
tion in SAFTEY section.
Confirm the accelerator pedal arm contacts the accelera-
tor pedal bracket when in the released position (Figure 6).
Road Test
Connect the negative (-) battery cable to the battery pack.
Item Torque Specification
18 60 - 72 in. lbs (7 - 8 Nm)




%GGIPIVEXSV4IHEP


%GGIPIVEXSV4IHEP
*PSSVFSEVH
2SXGL

Textron EZGO RXV 2016 Specifications

General

Brand	Textron
Model	EZGO RXV 2016
Category	Golf Cars
Language	English