12
SAFTEY
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
7. Lower the jack and test the stability of the vehicle on
the jack stands.
How to lift the rear of the vehicle only:
1. Install wheel chocks in front and behind each front
wheel.
2. Center the jack under the bagwell.
3. Put a block of wood between the jack and rear
bumper. Lift the vehicle enough to place two jack
stands under the frame where the leaf spring mount-
ing brackets are welded to the frame.
4. Lower the jack and test the stability of the vehicle on
the two jack stands.
Figure. 2 Lifting the Vehicle
Figure. 3 Wheel Chocks
How to Lift the Front of the Vehicle Only:
1. Install wheel chocks in front and behind each rear
wheel.
2. Place the jack under the center front just behind the
bumper.
3. Lift the vehicle and place two jack stands under the
frame where the instrument panel support is
attached to the frame.
4. Lower the jack and test the stability of the vehicle on
the two jack stands.
Lower the Vehicle:
1. Lift the vehicle enough to remove the jack stands.
2. Carefully lower the vehicle to the ground with the
jack.
To Next Page
Loading...
