WHEELS AND TIRES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
27
WHEELS AND TIRES
WHEEL AND TIRE SERVICE
Tool List Qty.
Lug Wrench, 3/4”......................................................... 1
Impact Wrench ............................................................ 1
Impact Socket, 3/4” ..................................................... 1
Torque Wrench, ft. lbs. ................................................ 1
To decrease the risk of tire explosion, add
small amounts of air to the tire at intervals to
seat the tire beads. Over inflation of small tires
can occur in a few seconds.
Do not over inflate the tires. Excess pressure
can cause the tire to separate from the wheel
or explode.
Protect face and eyes when removing a tire
valve core.
Use only sockets made for use with impact
wrenches to decrease the risk of injury caused
by a broken socket.
Do not use tires that have a recommended tire
inflation pressure less than the tire pressure
recommended in the vehicle owner's guide.
Use caution when you inflate the tires. Because of the low
volume of the small tires, over inflation can occur in sec-
onds. Over inflation can cause the tire to separate from
the wheel or cause a tire explosion.
The general recommended tire inflation pressure is 18-22
psi. Tire inflation pressure can be adjusted for the condi-
tion of the terrain.
For outdoor applications with primary use on areas with
grass, consider the following:
• Slightly higher tire inflation pressure is suitable on
hard turf
• A lower pressure decreases the risk of tires cutting
into a soft turf
For hard surfaces or pavement, tire inflation pressure
must be in the higher allowed range, but not more than
recommended on the tire sidewall.
All four tires must have the same pressure for best con-
trol qualities. Always install the valve stem cap after you
check or inflate the tires.
Tire Repair
The vehicle is fitted with low-pressure tubeless tires
mounted on one piece rims.
The most cost effective way to repair a flat tire with a
puncture in the tread portion of the tire is to use a com-
mercial tire plug.
For large holes and cuts, replace the tire.
Tire plug tools and plugs are available at automotive
outlets. The tires do not have to be removed from the
wheel to install the tire plugs.
If the tire is flat, lift the vehicle and remove the wheel.
Refer to the SAFETY section for the lifting procedure and
safety information. Inflate the tire to maximum recom-
mended pressure. Submerge the tire in water to find the
leak, and mark with chalk. Insert the tire plug in accor-
dance with manufacturers specifications.
If the tire is being removed or mounted, the tire-changing
machine manufacturers recommendations must be fol-
lowed to minimize the possibility of personal injury. Be
sure to place tire on wheel correctly. The arrow on the tire
indicates direction of rotation when moving forward.
To decrease the risk of injury, make sure the
mounting/demounting machine is anchored to
the floor. Wear OSHA approved safety
equipment when mounting/demounting tires.
Follow all instructions and safety warnings provided by
the mounting/demounting machine manufacturer.
Wheel Installation
To decrease the risk of component damage, do not
tighten lug nuts to more than 85 ft. lbs. (115 Nm)
torque.
Always follow the cross-sequence pattern when you
install the lug nuts to make sure the wheel is evenly
seated against the hub.
To Next Page
Loading...
Need help?
General
