124
WEATHER PROTECTION
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
REAR VIEW MIRROR WITH CANOPY
Tool List Qty.
Wrench, 12mm ............................................................ 1
Wrench, 15mm ............................................................ 1
Ratchet Handle, 3/8”.................................................... 1
Drive T-45 Torx Bit, 3/8”...............................................1
Phillips Bit, #2 .............................................................. 1
Wheel Chocks .............................................................1
Mirror Bracket Installation
• Attach the mirror bracket (2) to the strut by feeding
the torx bolt (3) through the existing slot located on
left and right front strut (Figure 6) (Figure 7).
• Place mirror bracket (2) up to strut and feed bolt (3)
through existing hole in the mirror bracket (2).
• Secure mirror bracket (2) tightly to strut using the nut
(4). Be sure to point mirror bracket outwards from the
vehicle
Figure 5 Rear View Mirror
Figure 6 Mirror brackets Installation
Figure 7 Mirror brackets Installation
Mounting Mirror to Bracket
• Remove the bolt that is already attached to the mir-
ror’s mounting arm. Keep the bolt for later installa-
tion.
• Slide the mirror’s mounting arm into open slot on
bracket (2).
• Using the existing bolt from mirror (1), secure mirror
to mirror bracket (2) .
• Use Phillips bit to adjust the direction of the mirror
7XVYX
*VSRXSJ:ILMGPI
7XVYX
*VSRXSJ:ILMGPI
To Next Page
Loading...
Need help?
General
