3
Learning Center
Basic Instrument Operations
Thermo Scientific NanoDrop One User Guide 219
Auto-Measure and Auto-Blank
Speed up sample analysis with the NanoDrop One Auto-Measure and Auto-Blank features,
which cause the instrument to start the measurement immediately after you lower the
instrument arm. These options eliminate the need for repetitive Measure or Blank operations
for large batches of samples.
Auto-Measure
To select or deselect Auto-Measure, from any sample measurement screen, tap the On or Off
button at the right of the Measure button.
Auto-Blank
To select or deselect Auto-Blank, from any blank measurement screen, tap the On or Off
button at the right of the Blank button.
End Experiment
Tap End Experiment when you are ready to name and save your experiment, add a label to
help you locate the experiment later (see Manage identifiers on the instrument), or export the
data.
Note Auto-Measure and Auto-Blank are available for micro-volume measurements only.
Note The End Experiment button is enabled after the first sample measurement is
completed.
To Next Page
Loading...
