5.10. SYSTEM SETTINGS
Note: For specific device settings and ranges, refer to Section 6 - Factory Default Programming.
The TSC 900 controller provides a flexible control system to allow specific operation for a wide
range of applications. To program settings, navigate to the “Settings” page as shown below.
Once on the Settings Page, select the group of Settings by adjusting the filter and scroll through
available list of functions as available.
System settings are organized into the following 3 main groups as selected by drop-down list
selection shown below:
• Basic - The Basic group contains the most commonly used settings to configure a
standard transfer switch.
• Advanced – Advanced settings group contains less commonly used features which
allow users to customize the operation of the transfer switch to suit the application.
• Factory - The Factory group of settings are only accessible through a Factory
password and allow the ATS to be configured for specific applications.
Refer to Section 6 for a complete list of all Settings and their associated groups.
To Next Page
Loading...
