EasyManua.ls Logo

Topcon MACHINE CONTROL AG System Five - Page 7

Topcon MACHINE CONTROL AG System Five
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table of Contents
P/N 7010-0369 www.topconpositioning.com
iii
Chapter 3
Laser Setup ........................................................... 3-1
Laser Placement ............................................................... 3-2
Small Project Laser Transmitter Placement .............. 3-3
Large Project Laser Transmitter Placement .............. 3-4
Laser Transmitter Calibration .......................................... 3-5
Laser Axis Alignment ...................................................... 3-7
Automatic Alignment ................................................ 3-7
Manual Alignment .................................................... 3-8
Conditions Affecting the Laser Transmitter .................... 3-11
Laser Drift ................................................................. 3-12
Atmospheric Laser Bending ...................................... 3-13
Setting Grade Reference Points ....................................... 3-14
Other Factors Affecting Quality ...................................... 3-16
Wind .......................................................................... 3-16
Dust ........................................................................... 3-16
Fog ............................................................................. 3-17
Curvature of the Earth ............................................... 3-17
Laser Accuracy and Repeatability ................................... 3-18
Chapter 4
Surveying .............................................................. 4-1
Overview .......................................................................... 4-1
Survey Preparation ........................................................... 4-2
Laser Transmitter Setup ............................................ 4-3
Initial Elevation Reference Selection ........................ 4-4
Perimeter Survey ............................................................. 4-5
Calculating the Average Fall ..................................... 4-7
Calculating the Slopes ............................................... 4-8
Irregularly Shaped Fields .......................................... 4-8
Steeply Sloped Fields ................................................ 4-9
Serpentine Survey ............................................................ 4-10

Table of Contents

Related product manuals