Firmware Version 3/4.31.37
Main Component Net Volume error on effected components would always be an
understatement in the amount of side stream net volume that flowed during the
previous main components with the common side stream.
Corrected placement of "*" when performing a sequential or ratio blend with a
side stream.
Updated application of API VCF and meter calibration to perform rounded
calculations.
Updated firmware version to 3.28.14
1/13/08 3.28.16 WJP (released to QA for testing)
Corrected placement of "*" on additive net on printed ticket.
Corrected titles on factory Optical Isolator Test.
Updated firmware version to 3.28.16
1/22/09 3.28.16 WJP (released to Measurement Canada for testing)
Added Meter Net/Gross to Component Status Screen.
Added Transaction Detail Record for Component Meter (Per Measurement Canada
Requirement).
Updated transaction database and transaction printing to support type 4 details.
Changed transaction database version to 3.28.16.
Kept firmware version the same since 3.28.16 was not released to production or
outside Toptech.
1/28/09 3.28.16 WJP
Added Analog Test/No Cal function to FCM 2 Factory Test.
1/30/09 3.28.16 WJP (Released)
Corrected bug in reading Modbus register 4180 (Preset Batch Rate).
On FCM II Factory Calibration function, increased threshold on missed COM
messages to avoid restarting calibration over again when FCM updates internal
EEPROM after a successful calibration.
3/4/09 3.28.17 WJP (released)
Corrected bug in TEC and TEC-ETH API tables where temp/10 was being delivered to
the calculation.
Corrected bug in TEC and TEC-ETH API tables where temp > ref_temp, calculation
would always produce grossly invalid value.
Added Preset Configuration Parameter "Stop Start Delay" to prevent stop and start
within x time to eliminate concern with Rogue Smith Pulsers.
Set parameter to 45 seconds to prevent Rogue Smith Pulsers from activating
alternate operating mode.
Do not raise an alarm; just start flow after delay expires.
Log message when Driver attempts to start flow within this time for later
analysis/tracking.
Updated Real Time Database version to 3.28.17.
Updated firmware version to 3.28.17.
2/26/09 3.29.01 WJP
Updated PetroPlus logo per customer supplied graphic.
To support dynamic Configuration Parameters that may change from general to W&M
controlled parameters, all W&M parameters have been moved into general areas and
the W&M Menu has been removed.
All W&M controlled parameters are now displayed in red and are still protected
from modification via the external W&M switch. Screens include RCU Setup, Bay
Setup, Preset Setup, Component Setup, Additive Setup, Additive Calibration, Meter
Proving, View Temperature, View Density, View Pressure, Temperature Comp, and
Pressure Comp. Alarm Setup
To Next Page
Loading...
Need help?
General
