©Tormach® 2020
Specifications subject to change without notice.
Page 7 Tormach 1100MX Operator's Manual (Version 0720A)
For the most recent version, see tormach.com/support
TABLE OF CONTENTS
4.8.3 Set Up the Coolant Kit 55
4.8.4 Install the Automatic Tool Changer (ATC) 56
Required Tools 57
Required Tools for Installation 57
Required Tools for Verification 57
Air Requirements 57
Prepare the Machine 57
Disassemble the Power Drawbar Button 57
Install the Air Cylinder 58
Mount the Automatic Tool Changer (ATC) Bracket 58
Install the Main Assembly 59
Level the Automatic Tool Changer (ATC) 59
Prepare the Machine 59
Examine Perpendicularity in the Y Direction 60
Examine Perpendicularity in the X Direction 60
Examine the Alignment of the Carousel Door Opening 60
Make Air Connections 61
Make Electrical Connections 62
Verify the Installation 62
Adjust the Tool Alignment and Set the Tool Tray Height and Encoder Position 63
4.8.5 Install the 4th Axis 64
Required Tools 65
Unpack the 4th Axis 65
Lubricate the Rotary Table 65
Adjust the Backlash 66
To Set the Backlash by Positioning the Backlash Adjustment Screw 66
To Set the Backlash by the Numbers 66
Mount the Rotary Table 67
Install the A-Axis Motor Driver 67
Verify the Installation 67
4.8.6 Install the Chip Pans 68
4.8.7 Install the Backsplash and Splash Guard 69
4.8.8 Install the Enclosure 69
Before You Begin 70
Required Tools 70
Install the Enclosure Panels 70
Install the Left Rear Panel 70
Install the Left Side Panel 71
Install the Left Side Window Retainers 71
Install the Left Front Panel 71
Install the Right Rear Side Panel 72
To Next Page
Loading...
