Toro Multi Pro 1200 - Page 200

Multi Pro 1200/1250Page 7 -- 38Drive Train
25.Disassemble fork shaft assemblies:
A. Remove spring pin (item 1) from 2nd--3rd fork
shaft assembly.
B. Removeshiftfork(item2)fromforkshaft(item3).
C. Remove spring pin (item 4) from 1st--Reverse
fork shaft assembly.
D. Remove fork (item 5) from fork shaft (item 5).
2
1
3
6
4
5
Figure 53
26.Disassemble differential gear assembly:
A. Use a bearing puller to remove bearing (item 1)
from differential case.
B. Remove retaining ring (item 2).
C. Use a bearing puller to remove bearing (item 3).
D. Loosen and remove twelve (12) flange head
screws (item 4) that secure ring gear (item 5) to dif-
ferential case.
E. Remove ring gear (item 5) from differential case
and remove two (2) alignment pins (item 6).
F. Drive spring pin (item 7) out of pinion shaft (item
8).
G. Remove pinion shaft (item 8) from differential
case.
H. Remove two (2) differential pinion gears (item 9)
and two (2) washers (item 10).
I. Remove L.H. side gear (item 11), R.H. side gear
(item 12) and two (2) thrust washers (item 13).
1
3
2
12
10
11
9
7
8
4
6
5
13
Figure 54
6
7
10
13
13
9
8
12
10
11
1
5
4
9
2
3
Figure 55