To Next Page

To Previous Page

[Counting condition] The number of times the print head moves up and down

with the solenoid for ribbon save is counted. (A set of up and down is counted

as one.)

The head up/down count is saved every 4 head up/down operations.

RIBBON

[Description] Ribbon motor drive time

[Range] 0 to 2000 hours

[Counting condition] Counted when the ribbon motor is driven while media feed

or printing. (Reverse feed is also counted.)

When the power is turned off, drive time of 10 seconds or less is rounded

down when backed up.

SOLENOID

[Description] Head-up solenoid drive time

[Range] 0 to 1000 hours

[Counting condition] Counted when the ribbon save operation is performed.

When the power is turned off, drive time of 10 seconds or less is rounded

down when backed up.

232C ERR

[Description] The number of times an RS-232C hardware error occurred

[Range] 0 to 255

[Counting condition] Counted when a parity error, overrun error or framing

error occurs.

SYSTEM ERR

[Description] The number of times a system error occurred

[Range] 0 to 15

[Counting condition] Counted when a system error occurs.

POWER FAIL

[Description] The number of times a momentary power interruption occurred

[Range] 0 to 15

[Counting condition] Counted when a momentary power interruption occurs.

<< ADJUST >>

Item

Description

Remarks

[PC]/[KEY]

FEED

Feed amount fine adjustment

-50.0mm to +50.0mm

CUT

Cut position (or strip position) fine adjustment

-50.0mm to +50.0mm

BACK

Reverse feed amount fine adjustment

-9.9mm to +9.9mm

TONE (T)

Print density fine adjustment

(Thermal transfer print mode)

B-EX6T1/T3: -20 to +20 step

B-EX4T1: -10 to +10 step

TONE (D)

Print density fine adjustment

(Direct thermal print mode)

B-EX6T1/T3: -20 to +20 step

B-EX4T1: -10 to +10 step

RIBBON TORQUE NORM

RBN (FW)