59
<< PARAMETER SETTINGS >>
[Description] Media feed to the print start position
[Values to be printed]
OFF: Disabled.
STD: Feeds the detected gap/mark to the print start position.
ECO: Feeds a gap/mark positioned between the print head and the media sensor, if any, to the print
start position.
ECO+Backfeed: Back feed follows the above ECO printer behavior.
MOVE TO TEAROFF [1] [2] [3]
[Description 1] Auto feed to the cut/strip position after printing
[Value to be printed 1]
OFF: Disabled.
ON: Enabled. The following media stop position fine adjustment value is also printed.
[Description 2] Media stop position fine adjustment value
Note: Printed only when the “Auto feed to the cut/strip position after printing” is set to ON.
[Value to be printed 2]
-5.0mm to+5.0mm
[Description 3] Feed mode
[Value to be printed 3]
MODE1: Feeds the media for fixed length.
B-EX6T1/T3: 16.5 mm
B-EX4T1: 13.7 mm
MODE2: Feeds the media backward for 6 mm, then feeds it forward for 3 mm. (Only when the cut
mode, thermal transfer, and feed gap sensor are selected.) In other conditions, the printer
feeds the media for fixed length.
B-EX6T1/T3: 16.5 mm
B-EX4T1: 13.7 mm
MODE3: Feeds the media for fixed length. This is an exclusive specification for issuing RFID media.
B-EX6T1/T3: 34.0 mm
B-EX4T1: 31.2 mm
[Description] Whether to enable the head-up function during cut issue or use the Rewinder
[Values to be printed]
OFF: The head-up function is disabled during cut issue or the rewinder is not used.
ON: The head-up function is enabled during cut issue or the rewinder is used.
[Description] Whether to use the ribbon saving module
[Values to be printed] B-EX6T1/T3
OFF: Not used.
ON:POSITION1:The ribbon saving module is used.(Head lever position: “Position1”)
ON:POSITION2:The ribbon saving module is used. (Head lever position: “Position2”)
*Currently, only Position1 is available to use since there is no distinguish between position1 and
position2.
[Values to be printed] B-EX4T1
OFF: Not used.
To Next Page
Loading...
