Toshiba B-EX6T Series - Page 61

60
ON:TAG: The ribbon saving module is used.(Head lever position: “TAG”)
ON:LABEL: The ribbon saving module is used. (Head lever position: “LABEL”)
PRE PEEL OFF [ ]
[Description] Whether to enable the pre-peel-off function
[Values to be printed]
OFF: Enabled.
ON: Disabled.
BACK FEED SPEED [ ]
[Description] Reverse feed speed
[Values to be printed]
STD: 3 ips
LOW: 2 ips
CALIBRATION [ ]
[Description] Automatic calibration
[Values to be printed]
OFF: Disabled.
ON TRANS.: Auto calibration is performed with transmissive sensor.
ON REFL.: Auto calibration is performed with reflective sensor.
ON ALL: Auto calibration is performed with both sensors.
ON TRAS+BF: Auto calibration is performed with transmissive sensor, then the media is reversely fed.
ON REFL+BF: Auto calibration is performed with reflective sensor, then the media is reversely fed.
ON ALL+BF: Auto calibration is performed with both sensors, then the media is reversely fed.
CODE PAGE [1] [2]
[Description 1] Character code selection
[Value to be printed 1]
PC-850
PC-852
PC-857
PC-8
PC-851
PC-855
PC-1250
PC-1251
PC-1252
PC-1253
PC-1254
PC-1257
LATIN9
Arabic
PC-866
UTF-8
[Description 2] Character “0” selection
[Values to be printed]
0: with slash
Ø: without slash
CTRL CODE [ ]
[Description] Control code type
[Values to be printed]
AUTO: Automatic selection
{,|,}: {,|,} method
ESC,LF,NL: ESC,LF,NL method
MANUAL: Any code (Described in hex. code)