Toshiba B-EX6T Series - Page 62

61
PEEL OFF STATUS [ ]
[Description] Whether to send a peel-off wait status to the host
[Values to be printed]
OFF: Not sent.
ON: sent.
USB I/F STATUS [ ]
[Description] Whether to send a response to the host via USB
[Values to be printed]
OFF: Not sent.
ON: Sent.
FEED KEY [ ]
[Description] Function of the [FEED] key
[Values to be printed]
FEED: The printer feeds one label.
PRINT: The printer prints data in the image buffer on one label.
KANJI CODE [ ]
[Description] Kanji code type
[Values to be printed]
TYPE1: Windows: WINDOWS codes
TYPE2: Original: Original codes
EURO CODE [ ]
[Description] Euro code setting
[Values to be printed]
20 to FF (Hex. code)
AUTO HEAD CHK [ ]
[Description] Whether to perform automatic print head check
[Values to be printed]
OFF: Not performed.
ON: Performed.
WEB PRINTER [ ]
[Description] Whether to use the printer as a web printer
[Values to be printed]
OFF: Not used.
ON INTERNAL: Used. (Internal memory is used.)
ON EXTERNAL: Used (External memory is used.)
RIBBON NEAR END [ ]
[Description] Ribbon near end detection
[Values to be printed]
OFF: Disabled.
30m: Ribbon near end status is detected when the remaining ribbon length is approximately 30 m.
70m: Ribbon near end status is detected when the remaining ribbon length is approximately 70 m.
EX. I/O MODE [ ]
[Description] Expansion I/O operation mode
[Values to be printed]
TTEC Standard: Standard mode
Inline: In-line mode
PAPER/RBN END [ ]
[Description] Printer behavior at label/ribbon end
[Values to be printed]
Stop immediately: When a label/ribbon end status is detected, the printer stops immediately.
Complete current: When a label/ribbon end status is detected, the printer prints the current label as far
as possible, and then stops.
MAXICODE SPEC. [ ]
[Description] Maxicode specification