MFP ENTRY GUIDE © 2021 Toshiba Tec Corporation All rights reserved
Overview
1 - 2
1.3 About Options
In order to enhance the functions of the MFP, various options have been prepared. There are two types
of options, paper handling options and system options. Major options and their functions are shown as
below.
* Care must be taken regarding the options with the software license function and the necessary
precautions are explained in another section. P. 5-6 “5.4 Addition of Functions”
Remarks:
The configuration of the options differs depending on the models.
Option names Explanations
Paper handling options
Dual Scan Document Feeder This option separates the original sheets, slightly slides
them and then transports them one by one to the
scanning position of the MFP. A scanner for scanning
the back side of the original is embedded. Due to this,
both the front and back sides of the original can be
scanned at the same time in one original feeding.
Reversing Automatic Document Feeder This option separates the original sheets, slightly slides
them and then transports them one by one to the
scanning position of the MFP. The front side of the
original is scanned at the scanning position. Then the
original is reversed to have its back side scanned.
Paper Feed Pedestal Up to two further drawers can be installed. Paper with
different sizes can be placed in each drawer of this
option.
Large Capacity Feeder This option enables the placing of a large amount of
paper.
Finisher This option exits printed or copied sheets of paper
having sorted and stapled them.
Saddle Stitch Finisher This is an option with the paper folding function and the
center stitching of the folded paper function embedded
into the above Finisher. The center stitching is called
“saddle stitch”.
System options
Fax Unit This option enables the fax function using a public line
in an MFP.
Wireless LAN / Bluetooth Module This option enables connecting to the network by Wi-Fi
or being connected by a mobile terminal by Bluetooth.
Data Overwrite Enabler * This option enables the use of the function to overwrite
scanned data in the HDD for security purposes. For
details, refer to the High Security Mode Management
Guide.
IPsec Enabler * This option enables the use of the IPsec function for
security purposes.
External Interface Enabler * This option enables the use of the browser function
which is operated on the control panel of the MFP.
External contents can be displayed by using this
browser.
Multi Station Print Enabler * This option enables making MFPs on the network
linked, so that printing can be performed in any of
them.
e-BRIDGE ID Gate This is a card reader option for performing user
authentication by an ID card. Depending on the region,
this is not configured as an option.
To Next Page
Loading...
