MFP ENTRY GUIDE © 2021 Toshiba Tec Corporation All rights reserved
PRECAUTIONS REGARDING MAINTENANCE
4 - 4
4.3 Jigs
A jig is a kind of tool used when assembling or adjusting parts in order to maintain the performance of
the MFP. The following is an example of jigs used for the MFP.
e.g.:
• Door switch jig: Use this to operate the MFP while the cover is opened.
Fig. 4-3
• Doctor sleeve gap jig: Use this to adjust the inside of the developer unit.
Fig. 4-4
• Wire holder jig: Use this when assembling the carriage wire of the scanner.
Fig. 4-5
To Next Page
Loading...
