MFP ENTRY GUIDE © 2021 Toshiba Tec Corporation All rights reserved
PRECAUTIONS REGARDING MAINTENANCE
4 - 2
3. Fans
An arrow mark as shown in the figure below is applied to almost all fans. This indicates the
flow of the air by means of the fan. Therefore, be sure to install the fan in the correct
direction.
Fig. 4-2
4. Gears
The attachment direction is specified for some gears and an application of grease on the
tooth surface is required for some. Therefore, handle the gears with care when installing
them.
5. Harnesses
Be sure to wire the harness correctly and not to get it caught between other parts. If it does
get caught, it will be open circuited.
To Next Page
Loading...
