7
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
PREVENTIVE MAINTENANCE (PM)
7 - 7
Notes:
• “—” is always displayed at the drive counts section for the reversing automatic document
feeder (RADF) and feed unit.
• The paper source differs depending on the structure of options, however, “0.0k” is displayed
in “OUTPUT PAGES (k)” and its standard number of output pages is displayed in “PM
OUTPUT PAGES (k)” even for the installed paper source.
2. Sub screen
Fig. 7-4
Displaying of the number of print / develop pages and drive counts and previous
replacement date for a chosen sub unit
Moving to the next/previous page
Displaying of the standard number of drive counts to replace the sub unit (parts)
Displaying of the present drive counts
“*” is displayed next to the present number when the number of drive counts has exceeded
its PM standard number.
Displaying of the standard number of print / develop pages to replace the sub unit (parts)
Displaying of the present number of print / develop pages
“*” is displayed next to the present number when the number of print / develop pages has
exceeded its PM standard number.
Displaying of the sub unit (parts) name
Moving to the clear screen to clear the selected unit (parts) counters
Back to the main screen
2
3
4
5
7
8
9
To Next Page
Loading...
