e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 118
[EA20] Paper transport stop jam
MJ-1101/1107
MJ-1106/1108
Finisher control PC board
(FIN)
• Board check
• Connector check (CN25, CN27)
• Harness check
Parts to be replaced Remark
Feeding sensor (S22)
Transport path switching
solenoid (SOL5)
Entrance motor (M1)
Interface PC board (I/F)
Finisher control PC board
(FIN)
Classification Error content
Paper jam in finisher section Paper transport delay jam
Check item Measures
Transport sensor • Sensor check
• Connector check (S2)
• Harness check
Finisher controller PC board Board check(CN22)
Parts to be replaced Remark
Transport sensor
Finisher controller PC board
Check item Measures
Finisher Check if there is any paper in the finisher or on the transport path of
the equipment and remove it if there is.
Entrance sensor (S1) • Sensor check
• Connector check
• Harness check
Finisher control PC board
(FIN)
• Board check
• Connector check (CN26)
• Harness check
Parts to be replaced Remark
Entrance sensor (S1)
Finisher control PC board
(FIN)
Check item Measures
To Next Page
Loading...
