Toshiba E-STUDIO3508A - Page 658

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 120
MJ-1101/1107
MJ-1106/1108
[EA23] Paper transport stop jam (transport sensor)
[EA24] Paper transport stop jam (between entrance & transport sensor)
[EA25] Paper transport stop jam (after paper stack exit)
[EA26] Paper transport stop jam (stop command request)
[EA27] Paper transport stop jam (paper not inserted)
[EA28] Paper transport stop jam (paper holder plate operation delay)
[EA29] Paper transport stop jam (stack transport delay)
Check item Measures
Entrance sensor • Sensor check(S1)
• Connector check (CN7, CN22)
• Harness check
Transport sensor • Sensor check(S2)
• Connector check (CN7, CN22)
• Harness check
Parts to be replaced Remark
Entrance sensor
Transport sensor
Finisher controller PC board
Check item Measures
Finisher Check if there is any paper in the finisher or on the transport path of
the equipment and remove it if there is.
Entrance sensor (S1) • Sensor check
• Connector check
• Harness check
Transport sensor (S2) • Sensor check
• Connector check
• Harness check
Finisher control PC board
(FIN)
• Board check
• Connector check (CN6, CN26)
• Harness check
Parts to be replaced Remark
Entrance sensor (S1)
Transport sensor (S2)
Finisher control PC board
(FIN)
Classification Error content
Paper jam in finisher section Paper transport stop jam