e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 206
MJ-1106/1108
[CC31] Transport motor abnormality
* You receive a [CC31] error when the [ED12] error occurs three times in succession.
MJ-1101/1107
MJ-1106/1108
Replacement part Measure
Stack transport motor (M5)
Finisher controller PC board
Check item Measures
Stack transport belt Move the stack transport belt.
Fix any mechanical problem.
Stack transport motor Check if the connector (CN17) on the finisher controller PC board is
disconnected from the stack transport motor (M8) and the
harnesses are open circuited. Correct if so.
Parts to be replaced Remark
Stack transport motor
Finisher control PC board
Classification Contents
Finisher related service call Transport motor abnormality: The transport motor is not rotating
or the stack transport roller -1 and -2 is not rotating normally.
Check Item Measure
Stack transport roller If there is mechanical problem when the stack transport roller -1
and -2 are rotated, fix the mechanism.
Transport motor (M2) Check the connectors and harnesses between the transport
motor (M2) and the finisher control PC board (CN5).
Replacement part Measure
Transport motor (M2)
Finisher controller PC board
Check item Measures
Stack transport roller -1
Stack transport roller -2
Rotate the stack transport roller -1 and -2.
Fix any mechanical problem.
Transport motor Check if the connector (CN10) on the finisher controller PC board is
disconnected from the transport motor (M7) and the harnesses are
open circuited. Correct if so.
Parts to be replaced Remark
Transport motor
Finisher control PC board
To Next Page
Loading...
