8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 207
[CC41] Paper holder cam home position abnormality
MJ-1101/1107
MJ-1106/1108
[CC51] Sideways adjustment motor (M2) abnormality
MJ-1101/1106 (when MJ-6103 is installed), MJ-1107/1108 (when MJ-6104 is installed)
* You receive a [CC51] error when the [ED11] error occurs three times in succession or occurs during
the initialization.
Classification Contents
Finisher related service call Paper holder cam home position abnormality: The paper holder
cam is not at the home position.
Check Item Measure
Paper holder cam If there is mechanical problem when the paper holder cam is
rotated, fix the mechanism.
Paper holder home position sensor
(S6)
Check the connectors and harnesses between the paper holder
home position sensor (S6) and the finisher control PC board
(CN17).
Replacement part Measure
Paper holder home position sensor
(S6)
Finisher controller PC board
Check item Measures
Paper pusher cam Rotate the paper pusher cam.
Fix any mechanical problem.
Paper holder home position
sensor
Check if the connector (CN9) on the finisher controller PC board is
disconnected from the paper holder home position sensor (S6) and
the harnesses are open circuited. Correct if so.
Parts to be replaced Remark
Paper holder home position
sensor
Finisher control PC board
Classification Contents
Finisher related service call Sideways adjustment motor (M2) abnormality: Sideways
adjustment motor is not rotating or puncher is not shifting
normally.
Check Item Measure
Transport path If there is any paper remaining on the transport path, remove
the paper.
Sideways adjustment motor (M2) • If there is mechanical problem when the sideways
adjustment motor (M2) is rotated, fix the mechanism.
• Check the connectors and harnesses between the hole
punch control PC board (HP) and sideways adjustment
motor (M2).
Sideways deviation home position
sensor (S3)
• Sensor check
• Harness check
To Next Page
Loading...
