e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
11 - 6
(4) Press the [ON/OFF] button while simultaneously holding down the [4] and [9] buttons.
Data in the USB device are checked and the checking status is displayed on the screen.
(5) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
Fig.11-3
The screen for selecting items to be updated is displayed after approx. 3 minutes.
On this screen, the current firmware version of this equipment and the firmware version of data to
be updated are displayed.
Fig.11-4
Enter Password
! “ # $ % & ‘ ( ) = ~ | ` { }
* < > ? _ . ^ @ + [ ] ; : / 1
Q W E R T Y U I O P 2 3
A S D F G H J K L 4 5 6
Z X C V B N M , . 7 8 9
Caps Space Backspace
Ok Reset
To Next Page
Loading...
