Toshiba e-STUDIO477SL - Color Conversion Table Selection

e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
4 - 22
4.4.15 Color conversion table selection
The color conversion table for each original mode at color scanning can be selected as follows.
<Adjustment Mode (05)>
Notes:
When "For reproduction of pure color" is selected, the colors other than pure colors of CMY
might change.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes to be adjusted and press the [START] button.
(3) Key in the adjustment value.
(To correct a value once keyed in, press the [CLEAR] button.)
(4) Press the [OK] or [INTERRUPT] button to store the value in memory.  The equipment goes
back to the ready state.
(5) Let the equipment restart and perform the scanning job.
(6) If the desired image has not been attained, repeat step (2) to (5).
Code Original mode Item to be adjusted Remarks
8305 Text/Photo Color conversion
table
0: Color conversion for text or photo
1: Color conversion for text/photo
2: For reproduction of pure color
* "For reproduction of pure color" increases
the color reproduction of the pure color patch
for CMY.
8308 Custom mode