Maintenance Utility Operating Manual 42678819FU02 - 29/38
(2) Changing the mode
Click the [Execute] button for the mode to set to display the confirmation window shown below.
Check the mode to be set, then click [OK] to download the mode. If the [Do not show this message next
time] checkbox is checked, this confirmation window will not be displayed the next time.
When the mode is downloaded successfully, the download completion window shown below appears.
Click [OK] in the download completion window to close the window.
(3) Going to the following function screen or finishing PU board setting
The [Next] button or the [Finish] button is inactive when the function screen is displayed and becomes
active by the following operation.
(a) Change the mode
(b) If it is unnecessary to set the Factory/Shipping mode, check the [Skip the setup and move on to
the next screen.] checkbox.
The screen changes to the following function screen or the "PU board setting - Finish Settings" screen
by clicking the [Next] button or the [Finish] button.
To Next Page
Loading...
