© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO477S/527S/477SL
REPLACEMENT OF PC BOARDS/HDD
6 - 27
6
(4) Press the [INSTALL] button.
(5) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK] button.
(6) Select the license to be installed, and then press the [INSTALL] button.
(7) The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(8) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
(9) Check that the installed license is displayed on the license list.
Remarks:
• If there are any other licenses to be installed, repeat from step (4).
• If there are no other licenses to be installed, press the [CLOSE] button, and then turn the
power OFF.
[L] Enable HDD encryption
If the HDD encryption function is used, follow the procedure below.
(1) Start up with the Setting mode (08).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(3) Enable the encryption function.
• For high security mode
Set the value of 08-8911 to "3".
• For enabling HDD encryption only
Set the value of 08-8911 to "1", and then set the value of 08-9379 to "1" (Security priority) or
"2" (Performance priority).
(4) Turn the power OFF.
[M] Adjust image quality
(1) Start up with the Adjustment mode (05).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(3) Perform “Automatic gamma adjustment” (05-7165).
P. 4-4 "4.2.1 Automatic gamma adjustment"
(4) Turn the power OFF.
[N] Initialize settings when FAX Unit (GD-1340) is installed
(1) Reinstall the FAX Unit (GD-1340).
(2) Start up with the Setting mode (08).
To Next Page
Loading...
