Toshiba e-STUDIO477SL - Density Adjustment of Graphic Lines (1200 Dpi)

4
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO477S/527S/477SL
SETTING / ADJUSTMENT
4 - 13
4.3.4 Density adjustment of graphic lines (1200 dpi)
This adjustment is available regardless of whether "Distinguish Thin Lines" of the printer driver is
selected or not.
<Adjustment Mode (05)>
Notes:
Be sure to set the values of the upper and lower limit properly so that they are not set in reverse.
<Procedure>
The procedure is the same as that of  P. 4-11 "4.3.1 Gamma balance adjustment (Black Mode)".
Color mode Code Remarks
Black
8242-0
The density of the line in Black in the line density range specified
by "05-8243-0" or "05-8243-1" can be adjusted.
The larger the value is, the darker the line density becomes.
Acceptable value: 0 to 5 (Default: 4)
Color mode Code Remarks
Black
8243-0 The effective range (lower limit) of the
density adjustment for the line in Black can
be set.
Acceptable value: 0 to 255 (Default: 1)
The density range
selected in the
upper and lower
limit is adjusted with
05-8242-0.
8243-1 The effective range (upper limit) of the
density adjustment for the line in Black can
be set.
Acceptable value: 0 to 255 (Default: 200)