Toshiba e-STUDIO477SL - SRAM Board <For SYS Board>

e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
6 - 6
6.1.5 SRAM board <for SYS board>
(5) Remove 3 screws.
Fig.6-16
(6) Remove 4 screws and take off the hard disk.
Fig.6-17
(1) Take off the right side cover.
 P. 6-1 "6.1.1 Right side cover"
(2) Take off the SYS board cover.
 P. 6-4 "6.1.2 SYS Board cover"
(3) Take off the fax unit if it's installed.
 P. 6-7 "6.1.6 FAX unit"
(4) Release 2 latches and take off the SRAM
board for the SYS board[1] with the case.
Fig.6-18