Toshiba e-STUDIO477SL - Hard Disk (HDD)

© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO477S/527S/477SL
REPLACEMENT OF PC BOARDS/HDD
6 - 5
6
6.1.4 Hard disk (HDD)
(5) Remove 2 screws.
Fig.6-13
(6) Remove 8 screws, and then take off the SYS
board.
Notes:
When removing the SYS board, do not apply
pressure to the heat sink, memory or SRAM
board by holding them too firmly.
Fig.6-14
(1) Take off the right side cover.
 P. 6-1 "6.1.1 Right side cover"
(2) Take off the SYS board cover.
 P. 6-4 "6.1.2 SYS Board cover"
(3) Take off the fax unit if it's installed.
 P. 6-7 "6.1.6 FAX unit"
(4) Unplug the connector connected to the hard
disk.
Fig.6-15