e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
5 - 28
5.3 Diagnosis and Prescription for Each Error Code
5.3.1 Check item
Check item Contents
Sensor check • Check the sensor in the test mode.
• Check that there is no dust on the sensor.
• Check that the actuator is correctly operated.
Connector check • Check that the connector is not disconnected.
• Check that the pins are not deformed and do not come off.
• Disconnect and reconnect the connector.
Harness check • Check if the harnesses are open circuited.
Motor check • Check the motor in the test mode.
• Check that there is no abnormality in the driving section.
• Check that there is no abnormality in the roller.
Board check • Check if the board is short circuited or open circuited.
To Next Page
Loading...
