e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 18
8.3 Firmware Updating with PWA-DWNLD-JIG2
The data to be overwritten by this update are as follows.
When the SYS board is replaced, update the ROM data written on SYS board as necessary.
Equipment
PWA-DWNLD-JIG2 (48MB)
Fig.8-12
[1] Connector (for SYS board connection)
[2] Connector (for ROM writer adapter connection)
Important:
The download jig (PWA-DWNLD-JIG2) is the jig in which the Flash ROM is mounted on the
board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the data to
these Flash ROMs. Refer to the following to write the data.
Remarks: Useable jigs
Download jigs for this equipment are as follows:
Firmware Stored
System firmware System control PC board
(SYS board)
No Type of jig ROM capacity Remarks
1 PWA-DWNLD-JIG1 16MB
2 PWA-DWNLD-JIG2 48MB
ROM1
ROM2
ROM3
ROM4
ROM5
ROM6
[1] [2]
To Next Page
Loading...
