Toshiba e-STUDIO477SL - Thin Line Width Lower Limit Adjustment; Upper Limit Value in the Toner Saving Mode

e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
4 - 12
4.3.2 Upper limit value in the Toner Saving Mode
The upper limit value of the density when "Toner save" is selected in the Custom tab of the printer driver
can be adjusted.
<Adjustment Mode (05)>
<Procedure>
The procedure is the same as that of  P. 4-11 "4.3.1 Gamma balance adjustment (Black Mode)".
4.3.3 Thin line width lower limit adjustment
<Adjustment Mode (05)>
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes to be adjusted and press the [START] button.
(3) Key in the adjustment value. (To correct the value once keyed in, press the [CLEAR] button.)
(4) Press the [OK] or [INTERRUPT] button to store the value in memory.  The equipment goes
back to the ready state.
(5) For resetting the value, repeat step (2) to (4).
(6) Let the equipment restart and perform the printing job.
(7) If the desired image has not been attained, repeat step (1) to (6).
Color PS PCL XPS 1200dpi Remarks
Black mode 7307-0 7307-1 7307-2 7302 The smaller the value is, the lighter
the density of image becomes.
Acceptable values: 0 to 255
(Default: 176)
Code Remarks
8240
(600dpi)
Sets the lower limit value of the thin line width when “Distinguish Thin Lines” is
selected in the screen selecting menu of the printer driver.
The larger the value is, the thicker (darker) the thin line becomes.
Acceptable values: 1 to 9
(Default: 1 for 8240 / 4 for 8241)
8241
(1200dpi)