e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
3 - 8
3.3 Input check (Test mode 03)
<Operation procedure>
Notes:
• Initialization is performed before the equipment enters the test mode.
• The PRINT DATA lamp blinks when the input check is running.
Fig. 3-5 Example of display during input check
Refer to "11. SELF-DIAGNOSTIC MODE" in this manual for the items to be checked and the condition
of the equipment when the buttons [A] to [H] are highlighted.
The status of each input signal can be checked by pressing the [FAX] button, [COPY] button,
[SCAN] button and the digital keys in the test mode (03).
[0][3]
[POWER]
[START] [Digital keys]
[CLEAR]
(LCD ON)
[POWER] OFF/ON
(Exit)
[CLEAR]
[FAX]
[COPY]
or
[SCAN]
To Next Page
Loading...
