Toshiba e-STUDIO477SL - Test Print Mode (Test Mode 04)

e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
3 - 10
3.5 Test print mode (test mode 04)
<Procedure 1>
Notes:
• When an error occurs, it is indicated on the panel, but the recovery operation is not performed.
Turn OFF the power and then back ON to clear the error.
• During test printing, the [CLEAR] button is disabled when “Wait adding toner” is displayed.
The embedded test pattern can be printed out in the test print mode (04).
[0][4]
[POWER]
[POWER]
OFF/ON
(Exit)
(Code) (Media selection)
[START]
[CLEAR]Operation
Continuous
Test Printing