e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
6 - 2
(3) Open the front cover and remove two
screws.
Fig.6-5
(4) Release 2 latches.
As shown in the figure, insert a flathead
screwdriver into the groove and push it in the
direction of the arrow to release the latches.
(only installed for e-STUDIO477S/527S)
Notes:
When using tools, be sure not to put your
face and hands in the direction in which force
will be applied; otherwise this could result in
injury. In addition, be sure not to damage the
cover.
Fig.6-6
(5) Release 2 latches.
As shown in the figure, insert a flathead
screwdriver into the groove and push it in the
direction of the arrow to release the latches.
(only installed for e-STUDIO477S/527S)
Notes:
When using tools, be sure not to put your
face and hands in the direction in which force
will be applied; otherwise this could result in
injury. In addition, be sure not to damage the
cover.
Fig.6-7
To Next Page
Loading...
