Image position and size
setting at the time of
forwarding received fax jobs
This setting is applied only when a received fax job
is forwarded with a pdf format file.
0: Sets to select the paper size from the drawers in
which paper is loaded by corresponding to an
image size. The image position is the upper part of
the paper.
1: Sets to select the paper size from the drawers in
which paper is loaded by corresponding to an
image size. The image position is the center part of
the paper.
2: Sets to select a standard size paper
corresponding to an image size. The image
position is the upper part of the paper.
- If "FAX" has been set as the attribute of a drawer,
its paper size will be applied when "0" or "1" is
selected.
Fax operation setting during
off-hook transmission
0: Transmission is not operable during off-hook
1: Direct transmission is operable during off-hook
2: Transmission is operable during off-hook
Waiting period for continue
after the RADF scanning
0: Disabled 1: Enabled
* When "Enabled" is set, the screen to notify
continuity appears for 1 second after RADF
scanning has been completed.
Process of user
authentification(ShimpleBind
)
0: Normal process
1: Special process
Addition of the QR code to
the total counter list
0: Disabled
1: Enabled
<Default value>
JPD: 1
Others: 0
Department management
setting(UserFunction)
User management
setting(UserFunction)
Setting for each debug log
file size
In one-go setting from a
USB storage device
When processing is carried out, a setting file is
read from a USB storage device and the setting
values of the self-diagnostic codes listed in the
setting file are written sequentially.
Self-diagnostic
codes in one-
go setting
Specifying whether to
display the network timeout
error page on the EWB or
not
0:Not displayed
1:Displayed
Change of Remote-access-
service user password
Maximum 65 letters
Sets a password for a built-in user "Remote-
access-service".
To Next Page
Loading...
