53
Chapter 6
Customize Your Network Settings
Follow the steps below to change your IP address.
1. Visit http://tplinkwifi.net and log in with the password you set for the mesh device.
2. Go to Advanced > Network > LAN Settings page and select IPv4.
3. Enter a new IP Address appropriate to your needs.
4. Select the Subnet Mask from the drop-down list. The subnet mask together with
the IP address identifies the local IP subnet.
5. Keep IGMP Snooping enabled by default. IGMP snooping is the process of listening
to IGMP (Internet Group Management Protocol) network traffic. The function
prevents hosts on a local network from receiving traffic for a multicast group they
have not explicitly joined.
6. You can configure the mesh device’s Second IP and Subnet Mask for LAN interface
through which you can also access the web management page.
7. Keep the rest settings as the default settings.
8. Click Save to make the settings effective.
6. 1. 3. Use the Mesh Device as a DHCP Server (AP Mode)
You can configure the mesh device to act as a DHCP server to assign IP addresses to
its clients. To use the DHCP server function of the mesh device, you must configure all
computers on the LAN to obtain an IP Address automatically.
Follow the steps below to configure DHCP server.
1. Visit http://tplinkwifi.net and log in with the password you set for the mesh device.
2. Go to Setting > Network > LAN Settings page and and change the LAN IP Address
Type to Static IP.
To Next Page
Loading...
