80
Chapter 8
to or from the same mesh device as Users. All accounts can monitor and manage the
mesh device locally or remotely, but user accounts cannot:
• Reset the mesh device to its factory default settings either on the web management
page or in the Aginet app.
• Add/remove other TP-Link IDs to/from the mesh device.
8. 3. 1. Add TP-Link ID to Manage the Mesh Device
1. Visit http://tplinkwifi.net and log in with your TP-Link ID.
2. Go to Setting > TP-Link Cloud (AP Mode) or Basic > TP-Link (Router Mode) , and focus
on the Bound Accounts section.
3. Click
, enter another TP-Link ID as needed and click Save.
Note: If you need another TP-Link ID, please register a new one via the Aginet app. Refer to Manage the Mesh Device
via the TP-Link Aginet App to install the app and register a new TP-Link ID.
4. The new TP-Link ID will be displayed in the Bound Accounts table as a User.
8. 3. 2. Remove TP-Link ID(s) from Managing the Mesh Device
1. Visit http://tplinkwifi.net and log in with your TP-Link ID.
2. Go to Setting > TP-Link Cloud (AP Mode) or Basic > TP-Link (Router Mode), and focus
on the Bound Accounts section.
3. Tick the checkbox(es) of the TP-Link ID(s) you want to remove and click Unbind.
To Next Page
Loading...
