67
Chapter 6
Customize Your Network Settings
Network roaming helps devices choose better AP based on actual conditions to balance
network demands. (For mesh devices, Band Steering is enabled by default.)
1. Go to Setting > Wireless > Wireless Settings (AP Mode) or Advanced > Wireless >
Wireless Settings (Router Mode).
2. Locate the Band Steering section, select the Enable check box to make the settings
effective.
6. 6. 2. Advanced Wireless Settings
Advanced wireless settings are for those who want more network controls. You can
follow the instructions below to configure your mesh device.
1. Visit http://tplinkwifi.net and log in with the password you set for your mesh device.
2. Go to Setting > Wireless > Advanced Settings (AP Mode) or Advanced > Wireless >
Advanced Settings (Router Mode).
¾ To change basic advanced settings:
Locate the Advanced Settings section and configure the advanced settings according
to the explanation below, and then click Save.
• Beacon Interval: Enter a value between 40 and 1000 in milliseconds to determine
the duration between which beacon packets are broadcast by the mesh device to
synchronize the wireless network. The default is 100 milliseconds.
To Next Page
Loading...
